RAIS X-Front User Manual download pdf (Page 47)

English RAIS - Manual for RAIS Q-Tee

Mounting of wall bracket and installation of Q-Tee Wall

The stove can only be mounted on non-combustible walls without cracks. Contact the

chimney sweep or building expert regarding the wall’s suitability. RAIS recommends that

hanging and installation of RAIS Q-TEE WALL should only be done by authorized dealers.

The bracket is mounted with screws suitable

to the type of wall. The bracket’s upper edge

should be horizontal. Note that the screw

head is not higher than 11mm. Plastic plugs

are not permitted. Bolts and other fastening

material are not included in the delivery from

RAIS.

The holes are marked up through the holes

in the bracket. All holes are drilled, a mini-

mum of 2 holes must be in a brick.

The ﬂue (4) with the seal is mounted on the

back of the stove with 3 M6 screws instead

the blanking plate.

The wall bracket (3) is centered in relation

to wall pipe in the wall or at the desired

distance above the ﬂoor.

Remove the knock-outs for the wall bracket (1) and

chimney (2) at rear of the stove (see section ‘Change

of chimney connection’). Remove

he blanking plate

and the packing and mount them on the stove top

outlet - please ensure that the gasket is properly

seated. Parts are screwed together with 3 M6 bolts.



Distance from wall to center of chimney is 141.5mm.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 207 208

No comments

RAIS X-Front User Manual Page 47